Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are great valve covers gaskets.
These are great valve cover gaskets. They're deep enough to accommodate most style rockers. They have a channel style gasket that can be reused. The only problem we've seen is that people tend to over tighten the cover and and that rips the gasket. We run the bolt down until it just hits the cover, then one more turn with the wrench.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101357
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101394
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 311101353A
New single port head.
Application:
These are great valve covers gaskets.