Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This pin is a must because it holds the axle nut on.
This pin is a must because it holds the axle nut on. It will not prevent a loose nut from ruining a drum, but it will keep the wheel on the car. We recommend tightening the axle nuts to 250 ft. lb., drive the Bug around the block and retighten the axle nut. Drive the Bug around the block again. If the nut moves when you torque it, drive around the block again. When it no longer moves, install the cotter pin. If the hole doesn't line up, tighten it up to the next hole. Whatever you do, don't loosen the axle nut to make the pin fit. Air wrenches DO NOT let you skip the trip around the block.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 141955425B
We carry Bosch blades for Bugs 1965 on.
Application:Part #: 111405692B
Front Bearing Grease Cap
Application:Part #: 311501221
A very important nut to say the least.
Application:Part #: 091311123
This is the main culprit of a noisy transmission.
Application:Part #: 1129701W
EMPI Deluxe Dual HPMX or IDF Manifold kit
Application:Part #: F1003
Permatex Form A Gasket
Application:Part #: 141707299A
Bracket Support Base Seals
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 111821715AOE
This is the beading that goes between the fender and the body.
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 241877306
These are all of the parts that we can get our hands on for metal sunroof bugs.
Application:Part #: 040101157
This plug goes in the back of the case (flywheel side).
Application:Part #: 1127105ALM
This is stainless steel braided fuel line.
Application:
This pin is a must because it holds the axle nut on.
