Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation. You should use one of these if you are not running a deep sump and drive corners too hard.
Bug (Type 1): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1198035C
Chromoly 8mm Head Stud Kit
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
