Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel. You will see a pin coming in from the side. Use a small punch or a nail with the head removed to drive the pin out. We suggest you do this in a clean area because the pin usually flies out and you will want to be able to find it. Once the pin is out, wiggle the handle and it will come off. On 1968 and later cars, you will need to pry out the plastic cover that is over the handle. Behind it you will need to remove the phillips screw. The handles that fit the Vanagon (#321 837 581) will work on the 68 and later Bugs, Buses and Type 3's and are a heavier duty than the stock one.
Bug (Type 1): 68-79
Bus (Type 2): 68-79
Vanagon: 80-92
Type 3: 68-74
Ghia: 68-74
Race/Off-Road: 68-79
No customer reviews for the moment.
Part #: 2101303
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 2821200
They are made of plastic and sold in pairs.
Application:Part #: 6115467B
These are a nice unit and much better for off road cars than the cast aluminum breather box.
Application:Part #: 111105271CO
Core
Application:Part #: 131721349
This adjustment nut goes on the end of the cable, back by the transmission.
Application:Part #: F1501
These are the glues and oils we use..
Application:Part #: 1141033
Cushion Clutch Disc - 200mm
Application:Part #: 311405625GR
These bearings go in the drum or rotor hub to allow them to spin. German
Application:Part #: 2129044
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1821715WH
This fender beading comes in a 25 foot roll.
Application:Part #: 1101447
Copper Cylinder Head Shims 94mm bore .050 (4)
Application:Part #: 211867515
Roof Lining, Gray, Original texture and style, Set of 2
Application:Part #: 6615104B
Front Rotor for Disc brake setup, 5/205 bolt pattern, 12x1.5mm threads 1966-
Application:Part #: 211415049FWG
If you have a lot of play in the steering don't just assume the steering box is bad. ******Due to the lack of cores that we have to rebuild, we require the core to be sent up front before we will send out a rebuilt box***
Application:Part #: 1800100F
This is a copy of the original EMPI license plate frame made years ago.
Application:Part #: 111821715AWH
This is the beading that goes between the fender and the body.
Application:
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
