Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. These are Chinese Pistons and Cylinders. We do not like the wire type of wrist pin keepers and suggest you buy a set of Tru-Arc type keepers. When you get pistons and cylinders, the pistons need to be taken out of the cylinders and have the cosmoline cleaned off and the ring gaps set. Note: The arrows on the pistons go towards the flywheel. If you want your motor to last, I suggest you flip ahead and read BARREL SHIMS.
Bus (Type 2): 2000
No customer reviews for the moment.
Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101386
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101477
These covers look good but have a tendency to leak.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N110071
Some of the more common nuts you might need..
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198162TS
92mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 2101306
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.