Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The striker is what keeps the door closed, an absolute necessary part to say the least. They are held in place by large screws. We suggest you use an impact drive to get the striker out. Note: Use masking tape to mark two sides of the old striker, so you will know where to set the new one. Before you completely tighten down the new striker, close the door and see how it lines up. If it lines up, tighten the screws. If it doesn't, start making adjustments until it does.
Bus (Type 2): 67-71
No customer reviews for the moment.
Part #: 043251051B
This is the exhaust silencer.
Application:Part #: 6881409ABKBL
High Back Seat Cover, Black and Blue w/ Square Pattern
Application:Part #: 153863402
This is a full carpet kit.
Application:Part #: 261813163
This is what the battery sits on.
Application:Part #: 6501500
The brackets can be used to change a swing axle torsion housing into an IRS housing.
Application:Part #: 141853335A
The front door window rolls up and down between these two rubber seals.
Application:Part #: 211857641A
Also known as the "oh shit" handle.
Application:Part #: 141955517
This switch controls the wiper motor.
Application:Part #: 2101306
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111141031E
This disc transfers the power from the motor to the transmission.
Application:Part #: 002141701A
This shaft holds the throw-out bearing in place.
Application:Part #: 211801052HL
This area tends to rust.
Application:Part #: 1251199
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 111881360
Sisel Padding, 28" x 6' per sheet.
Application:Part #: 133821306A
These are new rear fenders.
Application:
