Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Heater cables open the flaps in the heater boxes allowing heat into the car.
Heater cables open the flaps in the heater boxes allowing heat into the car. When you install the cables use white grease. Place the control(s) in the off position and crawl under the Bug and hook up the heater boxes. (A buddy sure would be helpful.) Now get back up and put the control(s) in the full on position and then crawl back under the car and push the lever on the heater box all of the way forward and lock into place. (Remember exercise is good for you.) Now recheck the levers to make sure they are closed when the control(s) are in the off position. On 1964 and earlier Bugs, the heater cable is attached to a slide. To get the slide out, twist the knob clockwise all the way. Just under the knob you will see a knurled collar. Wrap a rag around this collar and use a pair of pliers to unthread it. Once the collar is unthreaded you will be able to pull the slide out. When putting the slide back in make sure that the slot in the slide indexes itself to the spot on the slide hole.
No customer reviews for the moment.
Part #: 111827517
This is the seal that goes under the deck lid handle..
Application:Part #: F1863
These are the glues and oils we use..
Application:Part #: 113857219A
These are the clips that hold the various chrome moldings on. Sold each
Application:Bug (Type 1); Chrome molding seal 1950-1966, Door panel clip seal All
Ghia; All
Type 3; All
Off road: All
Part #: 111501303A
Outer Rear Wheel Bearing Spacer
Application:Part #: 151863014
These are the interior panels.
Application:Part #: 111945185
Taillight/Turn Signal Screw
Application:Part #: 1601028CH
EMPI 8 Spoke Chrome, 4x130, 5.5"x15"
Application:Part #: 151947511A
Interior Light Switch
Application:Part #: 141953161AAM
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 6721356A
Slave Cylinder Trans Bracket for Type 1 Transmissions
Application:Part #: VDO360023
These are the most common sending units.
Application:Part #: 113721221
Brake Pedal Push-Rod Lock Tab
Application:Part #: 211721617
Accelerator Lever Spring, (2 required)
Application:Part #: 133945224A
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 111883401
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 211843636B
Side Sliding Door Stricker Plate
Application:Bus (Type 2); 68-79
Heater cables open the flaps in the heater boxes allowing heat into the car.
