Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber. These don't normally need to be replaced unless they have been ground too far or too many times. On stainless steel valves, make sure you grind the keepers so that they don't touch each other when they're put in place. Stainless steel valves are soft and if you don't grind the keepers they will eventually pull through.
Bus (Type 2): 74
No customer reviews for the moment.
Part #: 2101303
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111698002
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 1129034E
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1129627
CB 650 Dual Valve Springs (Set)
Application:Part #: 111821508A
Right side Running Board High Quality
Application:Part #: 261845501
Rear glass for trucks
Application:Bus (Type 2); 68-79 single or double cab
Part #: 111863402
This is a full carpet kit.
Application:Part #: 113867504
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 021101417A
Exhaust Valve Guide
Application:Part #: 111837229C
These springs go behind the door panels to put tension on the door handle buffers.
Application:Part #: 111511245E
This rubber "donut" goes around the spring plate, allowing it to move up and down.
Application:Part #: 211711629B
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 3251006
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.