Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The rear wheel attaches to the rear brake drum.
The rear wheel attaches to the rear brake drum. Make sure you torque the axle nut to 250 ft. lb., we don't want any wheels falling off. We suggest you drive the Bug for a day and tighten the nut again. For some reason the nut seems to loosen up the first time. Always use a cotter pin to lock the nut. If the hole doesn't line up, tighten it a little bit more until it does. Never, ever back the nut off to line up the hole.
No customer reviews for the moment.
Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 131609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 113698261A
This kit is for rebuilding the wheel cylinder.
Application:Part #: 113611053B
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 113698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 113609537C
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 1721315
This chrome and rubber pedal pad kit fits over your stock pedals.
Application:Part #: 311945223C
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 221841645B
Cargo Door Handle Collar, Inner
Application:Part #: 151845521BAM
This seal is for the rear window. This is for a CONVERTIBLE ONLY.
Application:Part #: 211798005
Splash Pan Installation Kit
Application:Part #: 6885401BK
Rear Fiberglass Buggy Seat 37 3/4" Black Diamond Stitch Cover
Application:Part #: 113707156
Chrome Bumper Guards with Impact Strip
Application:Part #: 311721509
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer..
Application:Part #: 181517283A
These conversion flanges will allow you to run bigger stronger Bus or 930 CV joints..
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 265809591
Intermediate Rocker Panel Goes between Inner and Outer Rocker as a Reinforcement
Application:Part #: 111881795A
Seat Paperboard Backing, Set of 2
Application:Part #: 113517185C
These bearings go in the drum or rotor hub to allow them to spin.
Application:Part #: 1615111B
Rear Disc Brake Kit W E-Brake, 5x130 w/ 14x1.5mm threads or 5x4.75" w/ 12mm threads, IRS
Application:Part #: 6801121
These tabs are used for mounting just about anything to tubing..
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:
The rear wheel attaches to the rear brake drum.