Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the lenses that go over the front turn signal bulb holders.
These are the lenses that go over the front turn signal bulb holders. Don't over tighten the screws or the lens will crack.
Bug (Type 1): 58-63
Off-Road: 58-63
No customer reviews for the moment.
Part #: 211703391H
Front cross Brace
Application:Part #: 265809041A
Side Panel, Crew Cab Only, Left
Application:Part #: 112863404
These carpet kits are to be used with the original rubber floor mats.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 311615107BR
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: N177321
These are some of the fuses and bulbs that you might need.
Application:Part #: 113857551LWH
These are the visors you pull down to keep the sun out of your eyes.
Application:Part #: 111903137B
This is the belt that turns the generator.
Application:Part #: 6945200
These chrome steel bolt-on covers go right over the existing lense to give your tail lights "billet" look protection..
Application:Part #: 211703116
This is where you would put in the stock jack to jack up the bus.
Application:Part #: 113251265
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1800100R
This is a copy of the original EMPI license plate frame made years ago.
Application:Part #: 111809085CB
Fastening Panel, Rear Fender
Application:Part #: 6801212
These tabs are used for mounting just about anything to tubing..
Application:Part #: 311837658A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 1129040
We've found that dual carbs work better than any single carburator set up.
Application:
These are the lenses that go over the front turn signal bulb holders.
