Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This seal goes behind the flywheel.
This seal goes behind the flywheel. It should be replaced every time the flywheel is taken off. If your seal is leaking, take the flywheel off and pry the seal out. Now remove the shims and call a friend. Have your friend push and then pull the front pulley while you look at the rear main bearing. If the bearing is moving, a new seal will not solve your problem. The engine will have to be taken apart and the case will need to be machined. If it is not moving, then you will want to check your endplay before installing the new seal. See CRANKSHAFT ENDPLAY SHIMS for instructions on how to do this. Install the seal and make sure it's all the way in (about 1/16" past flush). If you do not have a flywheel seal installer, turn your old seal upside down and use it to drive the new one in using a hammer. Note: The endplay (amount the crank is allowed to move back and forth) is .003" to .005". This measurement is very important if you want the engine to last.
Bus (Type 2): 72-79
Vanagon: 80-91
No customer reviews for the moment.
Part #: 111198461BR
The crankshaft rides in the main bearing.
Application:Part #: 111105263A
The bolt that holds the crankshaft pulley on.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105251CH
This is a stock pulley that has been chromed.
Application:Part #: 111105401RC
Most people don't realize that these are one of the most important parts in the motor.
Application:Part #: 1105277
Here are some flywheel pins that give you more contact surface on the flywheel.
Application:Part #: 111903137S
Replacement Belt for Serpentine System
Application:Part #: 111903221S
Replacement Bearings for Serpentine System
Application:Part #: 113105701
These are the shells that go in the rods and ride on the crank.
Application:Part #: JC86060
Jaycee Billet 7" Crank Pulley for Street Cars, Blue
Application:Part #: 1903108RD
EMPI Serpentine Belt System Red
Application:Part #: 111105209
CRANKSHAFT GEAR, timing, 36hp engines
Application:Part #: 02110529124
Endplay Shim .24mm
Application:Part #: 113105231B
This gear matches up with the brass gear that is on the crank.
Application:Part #: JC86040
Jaycee Billet 7" Crank Pulley for Street Cars, Red
Application:Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:
This seal goes behind the flywheel.
