Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bus (Type 2): 68-79
No customer reviews for the moment.
Part #: 311881247
This knob and guide allows you to release the back of the front seat.
Application:Part #: 043131617B
This is a smog device.
Application:Part #: 113863703A
Black Over the Tunnel Floor Mat
Application:Part #: 6251205
2 Bolt Header Gaskets (Pair)
Application:Part #: 211401273
These are the rubber snubbers that are in between the front torsion bar arms.
Application:Part #: 211837016C
Front Door Lock Mechanism, Right, No rod and remote
Application:Part #: 133805451G
Front Cross Panel
Application:Part #: 021109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 1501622
Aluminum Wheel Spacer, Double Drilled 4x130 & 5x130; 1/4" Thick
Application:Part #: 211809506A
The lower part of the dog leg.
Application:Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 255853345
These chrome moldings for American style seals go around the windows and are just for looks.
Application:Part #: 1501621
Aluminum Wheel Spacer, Double Drilled 4x130 & 5x130; 3/8" Thick
Application:Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application: