Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 65-67
Off-Road: 65-67
No customer reviews for the moment.
Part #: 1198161
These rings are cast iron.
Application:Part #: 2847104CU
This makes the rear window pop out like the front windows.
Application:Part #: 113129027EMP
This is what delivers gas and air to the engine.
Application:Part #: 211405692B
Bearing Grease Cap, Right Side
Application:Part #: 311837625C
Vent wing seals on the front doors keep out the elements.
Application:Part #: 1129602
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 111837291
These handles go on the inside of the front doors to open them.
Application:Part #: 113903141B
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 6881406
Race-Trim Low Mount Seat Mounts
Application:Part #: 211707192
Plastic Bolt Cover
Application:Bus (Type 2); 73-79
Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:Part #: 311415812C
These are the ball joints on the tie rods.
Application:Part #: 1101000
This brace bolts up in the rear fender wells to hold up the rear end of the engine.
Application:
This is the mechanism that makes the window go up and down.
