Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cable pulls the arm that releases the clutch.
This cable pulls the arm that releases the clutch. When replacing the cable, it will last longer and work better if you use white grease on it and on the clevis pin or hook. The easiest way to replace a cable is to remove the nut(s) from the clutch arm at the trans. Pull the bowden tube out of the bracket so it is straight. Pull the cable out from the front and replace it in the reverse order. On 68-71 Buses a two bolt bell where the clutch pedal shaft is bolted to the frame will need to be removed to get to the clevis pin. It is good idea to replace the clevis pin at this time on buses. We recomend having a spare in the car, in case it breaks while out in the middle of nowhere.
Bus (Type 2): 55-61
No customer reviews for the moment.
Part #: 1127023
This block off is used in conjunction with electric fuel pumps and mounts in place of the manual fuel pump.
Application:Part #: 111957801H
This cable goes from the speedo to the driver side front wheel.
Application:Part #: JC86240
Jaycee Billet Sand Seal Pulley Hub
Application:Part #: 6415811C
Tapered Chromoly Bung, mainly used for fabricating Tie Rods on Offroad/Race Applications. Thread 7/8"-14 LH
Application:Part #: 211945161
Front Side Reflector Base
Application:Part #: 1601102A
Chrome Steel 60 Degree on the base of the lug nuts 14mm, Set of 4
Application:Part #: 1117007
This is the high-temp/pressure hose used for routing oil to coolers and filters.
Application:Part #: 211801361D
Cargo Floor Cross Member, U-Profile Cross Section, Sold Each
Application:Part #: 1117102
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1601104A
Long Wheel Studs, M12-1.5, Set of 5
Application:Part #: 143847319
Quarter Window Hinge Set, 6 plastic Pieces
Application:Part #: 021298001
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 113698700
Steel Brake Line Kit (6 Pieces)
Application:Part #: 029141025B
The clutch cover is also known as a pressure plate.
Application:Part #: 211955233
Sleeve for One Eyed Duck
Application:Part #: 6857641
This bar is made to fit 1 1/2" tubing and will give your petrified passenger something to hang on to..
Application:
This cable pulls the arm that releases the clutch.