Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Rear Bumper Mount, Left
Rear Bumper Mount, Left. Must be welded
Bug (Type 1): -1965
Offroad/Race: -1965
No customer reviews for the moment.
Part #: 231069321
These rubber kits are for restoring your camper style windows..
Application:Part #: 113129707A
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1601057CCAP
Replacement Chrome Center Cap for Corsa, 5-Rib, and GT 5 Rims
Application:Part #: 2251005
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1823022
This is a dress-up kit for the front and rear air intakes on your bug..
Application:Part #: 113853555B
These are the correct trim moldings for your running boards.
Application:Part #: 1415801N
Narrowed Tie Rods for Link Pin
Application:Part #: 211813355IX
This is a repair panel for the rear corner.
Application:Part #: 211953165C
This seals the front turn signal housing from the fender.
Application:Part #: 113819519C
This gasket goes around the fresh air box and seals against the hood.
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 111405681
This plate goes between the two nuts on each of the front spindles.
Application:Part #: 151845521DCL
This seal is for the rear window. This is for a CONVERTIBLE ONLY.
Application:Part #: 002141701A
This shaft holds the throw-out bearing in place.
Application:Part #: 153863014
These are the interior panels.
Application:
Rear Bumper Mount, Left