Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): left,10/52-55, Conv.,10/52-55
Bus (Type 2): right, 53-67
Race/Off-Road: left,10/52-55
No customer reviews for the moment.
Part #: 6301263
These mounts should only be used on cars that are not daily drivers.
Application:Part #: 4881213
We really like the style and comfort that these seats provide.
Application:Part #: 213707355A
Rear Bumper Overrider, Left
Application:Part #: 143845121CCL
This seal goes around the front window. Fits sedan and convertables.
Application:Part #: 113798074
This is the pin and the spring needed on the accelerator pedal.
Application:Part #: 211711189A
This coupler attaches the shift rod to the transmission.
Application:Part #: 1127113F
3/8" Hard Line to No. 6 Female
Application:Part #: 111501131
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 251611775A
This flex hose goes from the metal brake line to the front wheel cylinder.
Application:Part #: 1105219
This spacer goes between the steel cam gear and the brass distributor gear on the crank.
Application:Part #: 211698151F
These brake pads go into the calipers and are sold in sets of four; two per caliper.
Application:Part #: 113412305
Plastic Upper Strut Cover
Application:Part #: 143863704
This is a full carpet kit.
Application:Part #: 1405129A
These seals are far better than the stock arm seals.
Application:Part #: 113141181B
Guide Sleeve
Application:Part #: 1501205SW
Now you can dial in your suspension in an instant.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
