Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This is the grommet for the reservoir line(s) where they go into the master cylinder.
This is the grommet for the reservoir line(s) where they go into the master cylinder. On Bugs 1967 and newer, the master cylinder comes with the grommets already installed. On Bugs up to 1966, you'll have to buy a grommet, as they do not come with the master cylinder. We find on the 1966 and older Bugs, it's easier to put the grommet in the master cylinder if you put a little break fluid on the outside to help it slip in and then dip the metal line in the fluid and push it through the grommet. 22mmx12mm
No customer reviews for the moment.
Part #: 1411108
2" Narrowed Leaves for Ball Joint, 1 Set (2 sets required)
Application:Part #: 211798003
Rear Bumper Bolt Kit
Application:Part #: 241877305
These are all of the parts that we can get our hands on for metal sunroof bugs.
Application:Part #: 211611070CCH
Front Right Wheel Cylinder (2 Required) CHINA
Application:Part #: 1601104A4
Long Wheel Studs, M12-1.5, Set of 4
Application:Part #: 6801244
Billet Bracket Undrilled for 1.75" Tubing
Application:Part #: 151853111A
Door Panel Molding Set 6 pcs Convertible Only
Application:Part #: 1831052
These trim covers are for the interior of your car where your feet are likely to hit.
Application:Part #: 113611301G
The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 211945245A
This seal goes between the tail light housing and the body of the car..
Application:Part #: 04138
These are the parts found in the distributor.
Application:Part #: 113105231B
This gear matches up with the brass gear that is on the crank.
Application:Part #: 1129505115
These are some of the most common jets used. Sold in Pairs
Application:Part #: 6701062
The skid plate protects the motor and trans.
Application:Part #: N90305201
Intake Manifold Sleeve
Application:Part #: 2611011
This kit allows you to run a 71-79 bus master cylinder on a pre 66 bus.
Application: