Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This cap sits on the top of the brake fluid reservoir filler hole.
This cap sits on the top of the brake fluid reservoir filler hole. If you have the OE reservoir up to 1960, it takes a rubber plug. If you have a new reservoir, then it takes the screw on cap. If you over tighten the cap, it will split.
Bug (Type 1): -60
Bus (Type 2): -60
Type 3: -60
Ghia: -60
Race/Off-Road: -60
No customer reviews for the moment.
Part #: 111971115
The electrical harness runs everything on the car.
Application:Part #: 6703020
4 Point Show Bar Unassembled
Application:Part #: 111809022BX
Lower Wheel House, Right
Application:Part #: 112920542
42mm Main Venturi for EPC 48/51, 48IDA
Application:Part #: 6801236
Billet Univ Tach Mount Bracket for 1.5" Tubing
Application:Part #: 111721507FHD
This is the pedal that works the throttle.
Application:Part #: 211598101
A new assembly consists of a new axle with CV joints and boots, ready to install.
Application:Part #: 211817567
Gutter, Rear Corner fits both sides
Application:Part #: 1129729BKKIT
Dual Port Installation Kit utilizing Black Urethane Boots
Application:Part #: 131415802C
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: 111105223
This brass gear goes on the crank to turn the distributor drive shaft.
Application:Part #: 111943023B
This housing mounts on the deck lid to hold the light assembly for the license plate.
Application:Part #: 221817793BK
Fresh Air Flap Control Knob, Black
Application:Part #: 111943191
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 1511241
These grommets go on the spring plates in the torsion housing of your car.
Application:
This cap sits on the top of the brake fluid reservoir filler hole.
