Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
-Written by Steve Phillips for HotVWs Magazine- Building a Daily Driver - Part 2 The size of the motor is the bore and stroke. So what is a good size to have? Let’s talk about the two.
I have been getting asked alot what is a good engine combo for a daily driver. This is such a loaded question and everybody has their opinion on this subject. So I am going to explain how I pick out a motor combo and why.
Trying to decide between points or an electronic ignition? Let’s go look at both.
- Written by Steve Phillips for Hot VWs Magazine- We all know what a stock size pulley is, but does everyone know what a power pulley is? And if it actually gives you more power? How does a pulley do that? It's not driving a supercharger, so how does it work?
- Written by Steve Phillips for HotVWs Magazine - We got a lot of rain this winter, followed by a lot of sun and heat, so in this article I am going to tell you how to replace your windshield seal (works on any stationary seal).
- Written by Steve Phillips for HotVWs Magazine - What does Full Flowing a case mean? Well what it refers to is drilling and tapping one of the oil galleys on the engine case for a return line.
-Written by Steve Phillips for HotVWs Magazine- To paint a case or not to paint a case? I am seeing a lot of cases coming in our shop that are painted. Is this good or bad?
- Written by Steve Phillips for HotVWs Magazine - Last month we talked about pressure plates so I think it's only fitting to talk about the throw out bearing arm. Here I’m going to walk you through some common issues, and what to look for when replacing them.
- Written By Steve Phillips for HotVWs Magazine - Let’s talk about pressure plates; there are all kinds out there. In this article I would like to describe the different types, and styles.
- Written by Steve Phillips for HotVWs Magazine - What mounts should you run? There are a few different choices here. You have stock crap, you have stock Brazilian which are ok, you have urethane, and you have solid. In this article, I will go through the pros and cons of each.
- Written by Steve Phillips for HotVWs Magazine - Check this article out if you need help adjusting your pedal stops
- Written by Steve Phillips for HotVWs Magazine - In this article I am going to talk about a trick that I just starting doing with an electric fuel pump. As most of you know, I am not a fan of electric fuel pumps. Do I run them without a mechanical pump on cars? Sure, but only if the motor demands more fuel than a mechanical pump can give.
