Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls. 205mm/ 8"
No customer reviews for the moment.
Part #: 113611399
Brake Fluid Reservoir Pad
Application:Part #: 113405615DGR
These are the front drums that the brake shoes ride on.
Application:Part #: 113611015BH
This hydraulic cylinder feeds all the wheel cylinders.
Application:Part #: 113611301H
Brake Fluid Reservoir, 1967 Only
Application:Part #: 113611829A
Master Cylinder to Bulkhead Spacer
Application:Part #: 133698002
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 113609237H
These four shoes or linings are in the front drums and are sold on an exchange basis.
Application:Part #: 113721207A
Brake Pedal to Master Cylinder Pushrod
Application:Part #: 113698002A
Brake Spring Kit
Application: