Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This joint allows the axle to move up and down and turn on IRS cars.
This joint allows the axle to move up and down and turn on IRS cars. To check yours, take them off and tear them apart one by one and look for pits. It is not a good idea to mix parts from one joint to the other. If yours are ok, put them back together. Note: When putting them together look at the inner race and you will see a narrow gap between grooves and then a wide gap. Make sure that the narrow groove sits across from a wide groove on the outer race. Lost? Well, if you get it back together and the joint is locked up and the outer race won't move sideways on the inner one then you did it backwards.
No customer reviews for the moment.
Part #: 1501541
These control arm bushings on IRS control arms are a good way to stiffen up the flex that goes into the arms.
Application:Part #: 6501229AE
These are hardened aircraft quality CV joint bolts.
Application:Part #: 930332035
930 CV Joint End Cap
Application:Part #: 6501205SW
These plates are .250" thick, that means they can handle the abuse of off roading.
Application:Part #: 1511241
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 6511243
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 6517283002
These conversion flanges will allow you to run bigger stronger Bus or 930 CV joints..
Application:Part #: 1598021BL
These boots are great for your swing axle because they last longer than stock boots.
Application:Part #: 1511222
Polished Stainless Steel Torsion End Plate, Swing Axle, Pair
Application:Part #: 6501149100K
These boots and flanges are designed for axles with very long suspension travel.
Application:Part #: 1501191RD
This urethane snubber keeps the rear suspension from bottoming out hard.
Application:Part #: 6501199
17 1/2" Chromoly IRS Race Axles for Type 1 and 2 CV Joints
Application:Part #: 1501581
Chromoloy Rear Hub 5/130mm for Short Axle (each)
Application:Part #: 6517283091
These conversion flanges will allow you to run bigger stronger Bus or 930 CV joints..
Application:Part #: 6501203
19 1/4" Axles for Type 2 trans with 930 joints
Application:Part #: 6501149108BO
Overboot Only for 930 CV, Each Offroad applications
Application:
This joint allows the axle to move up and down and turn on IRS cars.
