Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what delivers gas and air to the engine.
This is what delivers gas and air to the engine. It would take a book to explain all of the symptoms of a bad carburetor. A simple check is to use a mirror and a flashlight to see if fuel is dripping onto the butterfly while the engine is idling. If it's dripping then there is a good chance it's bad. Another check is with the motor off, grab the throttle arm down where the butterfly shaft is and see if it moves back and forth. Again if it moves, the shaft is worn out and you should think about replacing it.
Bug (Type 1): -70
Bus (Type 1): -70
Ghia: -70
Off-Road: -70
No customer reviews for the moment.
Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 113129707A
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 113129034KIT
This adapter is used when you want to put a 30PICT carb on a dual port manifold. Will only work with a round bowl style carb. It will NOT work with a square bowl carb.
Application:Part #: 113129391
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 113129027H
This is what delivers gas and air to the engine.
Application:Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application:Part #: 1129517
Linkage Ball End Bushings, Pair
Application:Part #: 1129039
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129304040
These are some of the most common jets used. Sold individually.
Application:Part #: 112950501IDF
Mixture Screw for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129039E
Empi Dual 40mm Carburetor complete setup
Application:Part #: 1129511B
Kadron Carburetor Linkage Ball Socket Ends, 10/32 Left & Right, Pair
Application:Part #: 1129802
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129306050
These are some of the most common jets used.
Application:Part #: 113129323C
Here are some of the replacement parts for your stock carburetor.
Application:Part #: 1129505011
These are some of the most common jets used.
Application:
This is what delivers gas and air to the engine.