Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Fast Idle Screw and Spring
Fast Idle Screw and Spring
Bug (Type 1): IDA
Bus (Type 2): IDA
Type 3: IDA
Ghia: IDA
Thing: IDA
Offroad/Race: IDA
No customer reviews for the moment.
Part #: 2498211C
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard. These spindles will give you the stock ride and give you that lowered stance. They are sold on an exchange basis and come with new king pins. They do NOT come with link pins, so look at yours to see if you need new ones. Most of the time you do not need new ones...
Application:Part #: T1105245
If you're going to be putting more than one engine together, we highly recommend getting this seal installer.
Application:Part #: 151871047C
This boot keeps the wind from ripping up your top when it is down.
Application:Part #: 151871359A
These strips screw to the top.
Application:Part #: 111198553
Fuel pump rear for 40hp repair kit.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
Ghia: 40hp
Part #: 021903137A
This is the belt that turns the generator.
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 125121112
Exhaust nuts 12 Point 8mm-1.25, use 10mm 12 point socket (8 per kit)
Application:Part #: 311141025E
The clutch cover is also known as a pressure plate.
Application:Part #: 152701062Q
Floor Plate, Right, Convertible
Application:Part #: 113415801
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: 6941045
This is the headlight bucket you use in a fiberglass fender of a Baja Bug.
Application:Part #: 111971114
The electrical harness runs everything on the car.
Application:Part #: 021199231C
They mount on the crossbar of 68 and later Buses.
Application:
Fast Idle Screw and Spring
