Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what delivers gas and air to the engine.
This is what delivers gas and air to the engine. It would take a book to explain all of the symptoms of a bad carburetor. A simple check is to use a mirror and a flashlight to see if fuel is dripping onto the butterfly while the engine is idling. If it's dripping then there is a good chance it's bad. Another check is with the motor off, grab the throttle arm down where the butterfly shaft is and see if it moves back and forth. Again if it moves, the shaft is worn out and you should think about replacing it.
Bug (Type 1): 62-70
Bus (Type 2): 61-70
Ghia: 62-70
Off-Road: -70
No customer reviews for the moment.
Part #: 111129405C
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 113129191G
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129506IDF
Velocity Stack Covers, for IDF & HPMX Carbs, Pair Fits carbs with velocity stacks & no air cleaners
Application:Part #: 1129305040
These are some of the most common jets used. Sold in pairs.
Application:Part #: 1129034
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: N137761
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 112950505IDA
Stack Hold Down Tab
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 113129034KIT
This adapter is used when you want to put a 30PICT carb on a dual port manifold. Will only work with a round bowl style carb. It will NOT work with a square bowl carb.
Application:Part #: 1129515PR
Linkage Down Rod Extensions, Short & Long, Pair
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 1129026
34 Pict Carburetor spacer plate, measures 3/8" thick with 2 11/16" hole to hole
Application:Part #: 1129508
These are some of the most common jets used.
Application:Part #: 1129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129033
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 112950505IDF
Throttle Shaft Lock Tab Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:
This is what delivers gas and air to the engine.