Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bug (Type 1): 1600
Bus (Type 2): 1600
Ghia: 1600
Thing: 1600
Off-Road: 1600
No customer reviews for the moment.
Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application:Part #: 112950507IDF
Pump Jet Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129199150
Needle Valve for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 1.50mm
Application:Part #: 112950502IDF
Mixture Screw Spring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 112950501IDA
48 IDA Air Fuel Mixture Screw and Spring
Application:Part #: 112950505IDA
Stack Hold Down Tab
Application:Part #: 111198569A
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 112950502IDA
Stack Hold Down Screw and Washer
Application:Part #: 113129031K
This is what delivers gas and air to the engine.
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 1129033
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1129306050
These are some of the most common jets used.
Application:Part #: 112950501IDF
Mixture Screw for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129028
Replacement Tubes & Brackets only for Empi EPC 32/36F carbs
Application:Part #: 1129034
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 1129511A
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.