Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the shaft that the clutch pedal attaches to.
This is the shaft that the clutch pedal attaches to. This job is not fun, because you need to remove the pedal assembly, then drive the pin out that holds the clutch pedal to the shaft. Now drive the shaft out of the pedal. Use some white grease on the new shaft and install it in the reverse order. Note: It is a good idea to take the whole pedal assembly apart and regrease all the bushings while you have it out.
Bug (Type 1): 66-71
Type 3: 66-71
Ghia: 66-71
Race/Off-Road: 66-71
No customer reviews for the moment.
Part #: 111141177AS
These clips hold the throw-out bearing to the arm.
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 311141025E
The clutch cover is also known as a pressure plate.
Application:Part #: 111141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 1141028
Kennedy Stage 4, 3000 LB Pressure Plate
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 211141025D
The clutch cover is also known as a pressure plate.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 113141701F
This shaft holds the throw-out bearing in place.
Application:Part #: 111141719F
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 311141025C
The clutch cover is also known as a pressure plate.
Application:Part #: 111141723A
Return Spring For Cross Shaft
Application:Part #: 113198026
This kit contains a bushing, a clutch return spring and the retaining clips to install the throw-out bearing shaft in the transmission.
Application:Part #: 1141025
Heavy Duty Clutch Pressure Plate - 1700lbs. This is made by KEP
Application:Part #: 311141031B
This disc transfers the power from the motor to the transmission.
Application:Part #: 1198026A
This kit contains a quality urethane bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:
This is the shaft that the clutch pedal attaches to.
