Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This grommet goes around the fuel line to protect it from getting cut (due to vibrations) where it comes out of the tunnel through the pan.
This grommet goes around the fuel line to protect it from getting cut (due to vibrations) where it comes out of the tunnel through the pan. Old grommets are usually fine, but if you don't have any, buy some and get them into place. If the fuel line gets cut, not only do you have a very hazardous bomb on your hands, but the fuel line is welded into the pan and is almost impossible to replace. This grommet is a must have.
Bug (Type 1): All
Ghia: All
Type 3: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 343201551
The most common reason, for replacing a cap is forgetting to put it back on at the gas station. Cap you get might not look like the one in the picture.
Application:Part #: 111809599A
Fuel Neck Seal, Neck to Opening
Application:Part #: 113919051F
The sending unit registers the fuel level on the gauge.
Application:Part #: 113201075ABX
These are new Brazilian tanks.
Application:Part #: 111209113A
Fuel Tap Rebuild Kit
Application:Part #: 113201557E
Gas cap gasket
Application:Part #: 111201557B
Gas Cap Gasket, 100mm
Application:Part #: 111201261
Fuel Breather Hose Clip
Application:Part #: 111201551AL
Locking Gas Cap
Application:Part #: 113201215
This is a small rubber sleeve that goes on the neck of the gas tank before you slide the fuel filler hose on..
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 133201075G
These are new Brazilian tanks.
Application:Part #: 111209175B
Grommet for Reserve Lever
Application:Part #: 211201557F
Gas Cap Gasket
Application:Part #: 131298221
This pipe comes out of the bottom of your gas tank.
Application:
This grommet goes around the fuel line to protect it from getting cut (due to vibrations) where it comes out of the tunnel through the pan.