Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are new Brazilian tanks.
These are new Brazilian tanks. There are four 13mm headed bolts holding it. Make sure you are using German fuel line when putting it back in. The 61-67 tanks take a different cap, which is the same as a 68- one. Caps are separate. For Buses, you will need to have the motor out. Trucks, the tank is in the bed. It is a good idea to buy a neck collar when replacing a tank. NOTE: Disconnect the battery when replacing the tank.
Bug (Type 1): 71-74
No customer reviews for the moment.
Part #: 803201511E
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 111919051
Fuel Tank Sending Unit
Application:Part #: 113919133
The sending unit registers the fuel level on the gauge.
Application:Part #: 111201551AL
Locking Gas Cap
Application:Part #: 111201557B
Gas Cap Gasket, 100mm
Application:Part #: 131298221
This pipe comes out of the bottom of your gas tank.
Application:Part #: 111201635A
Fuel Tank Clamp Plate
Application:Part #: 111201621B
Fuel Tank to Body Seal, Fiber
Application:Part #: 111209181
Reserve Lever Clip
Application:Part #: 113201215
This is a small rubber sleeve that goes on the neck of the gas tank before you slide the fuel filler hose on..
Application:Part #: 113919049D
The sending unit registers the fuel level on the gauge.
Application:Part #: 321201551H
The most common reason, for replacing a cap is forgetting to put it back on at the gas station.
Application:Part #: 311201219A
This hose goes from the filler neck to the tank.
Application:Part #: N203631
Vent Hose, Filler to T, 14mm x 215mm
Application:Part #: 111809931
Fuel Filler Door Spring
Application:
These are new Brazilian tanks.