Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Some of the more common nuts you might need..
Some of the more common nuts you might need.
No customer reviews for the moment.
Part #: 1105402
I-Beam Rod, 5.500", VW Journal 2.165"/55mm (EMPI 3/8" Rod Bolts), Set of 4
Application:Part #: 1107435
Not our favorite type of piston pin keeps.
Application:Part #: 111801171C
The heater channel carries heat form the heater boxes to the front of the car.
Application:Part #: 211837295D
The striker is what keeps the door closed, an absolute necessary part to say the least.
Application:Part #: 113115181A
This is the plate on the bottom of the motor.
Application:Part #: 1711108
EMPI Polished Aluminum T-Handle Shifter, Short, 10" OAL
Application:Part #: 211809324
C-Post Repair Section, Inner, Right 370mm tall (14.6 inches)
Application:Part #: VDO360006
Oil pressure sending unit with pole for dash light
Application:Part #: 211611741B
These are the metal brake lines found throughout the car.
Application:Part #: 211863112
These are the interior panels.
Application:Part #: N142268
This is a list of the most common screws you might need..
Application:Part #: 211801051IR
This area tends to rust.
Application:Part #: 113701293C
This boot goes in the pan to encase the throttle and clutch tubes that come out of the pan.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1251161
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:
Some of the more common nuts you might need..
