Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:Heater cables open the flaps in the heater boxes allowing heat into the car.
Heater cables open the flaps in the heater boxes allowing heat into the car. When you install the cables use white grease. Place the control(s) in the off position and crawl under the Bug and hook up the heater boxes. (A buddy sure would be helpful.) Now get back up and put the control(s) in the full on position and then crawl back under the car and push the lever on the heater box all of the way forward and lock into place. (Remember exercise is good for you.) Now recheck the levers to make sure they are closed when the control(s) are in the off position. On 1964 and earlier Bugs, the heater cable is attached to a slide. To get the slide out, twist the knob clockwise all the way. Just under the knob you will see a knurled collar. Wrap a rag around this collar and use a pair of pliers to unthread it. Once the collar is unthreaded you will be able to pull the slide out. When putting the slide back in make sure that the slot in the slide indexes itself to the spot on the slide hole.
No customer reviews for the moment.
Part #: 151871195A
This is the pad between the top material and the headliner.
Application:Part #: 111881795B
Seat Paperboard Backing, Set of 2
Application:Part #: 211837235AGY
This plastic "donut" goes under the window crank or door handle to prevent the door panel from getting ripped.
Application:Part #: N171211
These are some of the fuses and bulbs that you might need.
Application:Part #: 311853535C
Chrome Aluminum Molding Kit, 8 Piece without Side Marker
Application:Part #: 113863717C
Rear floor mat
Application:Part #: 6707102
These bumpers are made for Baja Bugs.
Application:Part #: 043251051B
This is the exhaust silencer.
Application:Part #: 113721335A
This cable pulls the arm that releases the clutch.
Application:Part #: ST1004
Stickers for you car or tool box.
Application:Part #: 4881405CU
Like the custom door panels these car seat covers are a great way to customize the interior of your Bug.
Application:Part #: 6251005BEND
These systems work well with a single carb set up as they have provisions for the heat riser.
Application:Part #: 1105219
This spacer goes between the steel cam gear and the brass distributor gear on the crank.
Application:Part #: 15186337711
Rear Kick Panels, Convertible only
Application:Part #: 68012024C
Set of 4 Chromoly Universal Mounting Tabs with 3/8" hole
Application: