Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These joints are located in the ends of the control arms.
These joints are located in the ends of the control arms. You will need a press and some special tools to replace the joints on a standard Bug. Note: Remove the boot before you press the joint in the arm and then put it back on after. There are four ball joints per car on a standard Bug. Super Beetle ball joints just bolt on and there is only one per side.
Bug (Type 1): 71-5/73
No customer reviews for the moment.
Part #: 1601068C
Empi Cosmo, 5x205, 15x5.5"
Application:Part #: 211405371WGC
CORE CHARGE If you would like to order these before sending your old arms in, please add part number 211405371WGC to your order. This is the core charge. Once you send back your old arms we will refund that amount, providing your arms are good.
Application:Part #: 2101474
These bolt on valve covers are for the pancake style engine.
Application:Part #: 311971014
The electrical harness runs everything on the car.
Application:Part #: 2881404CU
Like the custom door panels these car seat covers are a great way to customize the interior of your Bug.
Application:Part #: 1511228
This cap goes over the torsion bar end of the spring plate holding the grommet.
Application:Part #: 211841691A
These rubber bumpers go on the side doors to keep them from banging into the body on buses 1950-1967.
Application:Part #: 211809506B
The lower part of the dog leg.
Application:Part #: 311301265B
These rubber mounts hold the transmission in place.
Application:Part #: 111941161A
These are a sealed unit.
Application:Part #: 211943131C
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 2847103CU
This makes the rear window pop out like the front windows
Application:Bus, (type 2); 64-79
Part #: 181517283A
These conversion flanges will allow you to run bigger stronger Bus or 930 CV joints..
Application:Part #: 211943131D
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 1898123
These window seals don't have the groove in them for the chrome trim, giving the car the Cal Look.
Application:
These joints are located in the ends of the control arms.