Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These joints are located in the ends of the control arms.
These joints are located in the ends of the control arms. You will need a press and some special tools to replace the joints on a standard Bug. Note: Remove the boot before you press the joint in the arm and then put it back on after. There are four ball joints per car on a standard Bug. Super Beetle ball joints just bolt on and there is only one per side.
No customer reviews for the moment.
Part #: 211609701C
Emergency Brake Cable (3330mm/131.1")
Application:Part #: 111857233AA
Radio Block Off Plate with chrome strip and clips
Application:Part #: 231067983
Replacement canvas for your camper.
Application:Part #: 2498211A
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard. These spindles will give you the stock ride and give you that lowered stance. They are sold on an exchange basis and come with new king pins. They do NOT come with link pins, so look at yours to see if you need new ones. Most of the time you do not need new ones as...
Application:Part #: 251201075AH
Fuel Tank 48mm Filler 11mm Outlet
Application:Part #: 111251051L
This is the exhaust silencer.
Application:Part #: 211698411
This kit is for rebuilding the wheel cylinder.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 211415801F
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: 113201557E
Gas cap gasket
Application:Part #: 311415811C
These are the ball joints on the tie rods.
Application:Part #: 211813164
This is what the battery sits on.
Application:Part #: 1105297
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 1115142HD
This oil pump cover comes with a threaded boss.
Application:Part #: 211809102B
This is what everyone cut out in the 60's.
Application:
These joints are located in the ends of the control arms.
