Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These ride against the cam. We prefer the Mahle or Scat brand for the upright engines. We personally have had bad luck with regrinds. If you are going to use used ones, clean the head surfaces and put two together with the faces touching. Hold them up to a light to see if you can see light between them increasing from the middle out. In other words the heads should be convex not concave or flat. Note: When installing, make sure your cam has .060 to .100" clearance from the top of the cam lobe to the lifter. Install using cam assembly lube.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 021198541
The cam rides in these bearings.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 021109111G
Aluminum Cam Gear
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109399
1.25 Ratio Rockers ONLY
Application:Part #: JC91020
Jaycee Leak proof Pushrod Tubes, Black
Application:Part #: 022109021A
Camshaft for 2.0L Bus for Hydraulic Lifters
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 022109309
These ride against the cam.
Application:Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 113109345A
These are the seals that go around the push rod tubes.
Application:Part #: 1109337
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: 1109601
These caps go on the ends of the valve.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application: