Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These joints are located in the ends of the control arms. You will need a press and some special tools to replace the joints on a standard Bug. Note: Remove the boot before you press the joint in the arm and then put it back on after. There are four ball joints per car on a standard Bug. Super Beetle ball joints just bolt on and there is only one per side.
Type 3: 62-74
No customer reviews for the moment.
Part #: 113823731B
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 111943191C
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 211837635A
Vent Window Latch Plate, Chrome, fits both sides, Each
Application:Part #: 111953193E
This seals the front turn signal housing from the fender.
Application:Part #: 211405671A
Wheel Bearing Nut, Front Left, 28mm Wheel Nut
Application:Part #: N113121
Some of the more common nuts you might need..
Application:Part #: 261863013
These are the interior panels.
Application:Part #: 1863620CS
Center Console Basket (Small) Chrome
Application:Part #: 04170
These are the parts found in the distributor.
Application:Part #: 251807221A
This rubber strip goes in the middle of the bumper..
Application:Part #: 113798053A
This is what gets smashed up first in an accident.
Application:Part #: 2711100PL
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Application:Part #: 1405314
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard.
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 211255719G
Heater Tube Insulating Cover, Pipe to Heater Box
Application:Part #: 111821531ATN
Tan Running Board Material, Left
Application:
