Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings. On the case half with the six main studs you should have four pins. You will have just one pin in the center main on the other case half.
Bug (Type 1): 56-79
Bus (Type 2): 50-79
Type 3: 62-73
Ghia: 56-74
Thing: 73-74
Race/Off-Road: 56-79
No customer reviews for the moment.
Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: N0145051
Some of the most common studs you might need.
Application:Part #: 1115105E
Oil Pick Up Tube Cut To Length
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1115107
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 113101219
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 111198003
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
