Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
All kits come with pistons, cylinders, rings, wrist pins and clips. Many of the kits will require machine work to the heads and case. Before you buy a kit, you should have a good understanding of how to set the compression ratio. Many people think that bigger motors are unreliable. This is just not true. When a motor is properly designed and built, it can be very dependable. You will not realize the full potential of the bigger pistons, unless you run big valve heads. There is a lot of information needed, so call us and we will gladly help. Note: The only thing we don't like about these kits are the rings and the wrist pin clips.
Bug (Type 1): All
Bus (Type 2): All
Ghia: All
No customer reviews for the moment.
Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 113101355A
New dual port head
Application:Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111198157B
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 1101351
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1109602
Valve seats are used in the big valve heads.
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
