Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Heater cables open the flaps in the heater boxes allowing heat into the car.
Heater cables open the flaps in the heater boxes allowing heat into the car. When you install the cables use white grease. Place the control(s) in the off position and crawl under the Bug and hook up the heater boxes. (A buddy sure would be helpful.) Now get back up and put the control(s) in the full on position and then crawl back under the car and push the lever on the heater box all of the way forward and lock into place. (Remember exercise is good for you.) Now recheck the levers to make sure they are closed when the control(s) are in the off position. On 1964 and earlier Bugs, the heater cable is attached to a slide. To get the slide out, twist the knob clockwise all the way. Just under the knob you will see a knurled collar. Wrap a rag around this collar and use a pair of pliers to unthread it. Once the collar is unthreaded you will be able to pull the slide out. When putting the slide back in make sure that the slot in the slide indexes itself to the spot on the slide hole.
No customer reviews for the moment.
Part #: 321837581ABK
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
Application:Part #: 211809187
Side Strengthening Panel 1.9 meters long (74.8")
Application:Part #: JC22370
Jaycee Fuel Pump Block off w/ AN 8 Fitting, Red
Application:Part #: 6863010AL
These won't warp when they get wet and mud washes off easily..
Application:Part #: 113819719A
These are the vents that clip into the dash.
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1101352
.
Application:Part #: 6415060B
This mount is used with the stock steering box.
Application:Part #: N177322
These are some of the fuses and bulbs that you might need.
Application:Part #: 113853345B
These chrome moldings for American style seals go around the windows and are just for looks.
Application:Part #: 1129505
Empi 40/44/48 IDF & HMPX Extended Emulsion Tube Holder
Application:Part #: 2251006CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 211405371WGC
CORE CHARGE If you would like to order these before sending your old arms in, please add part number 211405371WGC to your order. This is the core charge. Once you send back your old arms we will refund that amount, providing your arms are good.
Application:Part #: 111809939C
This is the cable that opens the gas door..
Application:Part #: 211867500
This is the vinyl covering for the inside roof and sides of the Bus.
Application:Part #: 1601153EXT
Replacement Extended Center cap for Sprintstar, Riviera, and 914 rims
Application:
Heater cables open the flaps in the heater boxes allowing heat into the car.
