Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This adjustment nut goes on the end of the cable, back by the transmission.
This adjustment nut goes on the end of the cable, back by the transmission. Always use some grease on the threads to make further adjustments easier. Tighten the nut until you can barely move the arm (about 1/8"). This adjustment translates into 2" of freeplay at the top of the clutch pedal.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 211843703H
Cargo Door Handle
Application:Part #: 1105259
This is a chrome stock bolt and washer that holds the crankshaft pulley on.
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 111899117B
This is a little square pad that goes on the torsion housing where the body mounts.
Application:Part #: 1707302
Stainless Steel Rear Bumper Overrider Set
Application:Part #: 211837626
Vent wing seals on the front doors keep out the elements.
Application:Part #: 141941041
This is the bucket that the bulb fits into.
Application:Part #: 143863011
These are the interior panels.
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: 141837253B
These are the stops on the check rods that prevent you from opening the doors too far.
Application:Part #: 1903108PL
EMPI Serpentine Belt System
Application:Part #: 111827517
This is the seal that goes under the deck lid handle..
Application:Part #: 2251006CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 6801232
Billet Bracket for 3/16" Brake Line, for 1" Tubing
Application:Part #: 211805212
Inner Front Lower Panel
Application:
This adjustment nut goes on the end of the cable, back by the transmission.
