Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rods link the cam to the valves. These are very costly so please call for good used ones.
These rods link the cam to the valves. If you have used rods, make sure that they are straight by rolling them on a flat surface. Inspect the ends and blow air through the tip making sure it comes out the other side. We do not recommend using steel push rods on a daily driver, because the expansion rate is different and requires you to adjust the valves more often. Note: When installing push rods, squirt some oil on the ends and down the hole.
No customer reviews for the moment.
Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 111198541HD
The cam rides in these bearings.
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 1109623
These are single heavy duty valve springs which are used on engines with Engle 110 or larger cams.
Application:Part #: 1109460
These shims are used under the rockers to set the geometry.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 1109642
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 111109301A
These rods link the cam to the valves.
Application:Part #: 1109341OR
Replacement O-Ring Set 16 pieces
Application:Part #: 1109415
These shims are used under the rockers to set the geometry.
Application:Part #: JC91000
Rebuild kit for Jaycee Leak proof Pushrod Tubes
Application:Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: JC91010
Jaycee Leak proof Pushrod Tubes, Red
Application:Part #: 113109651A
These springs return the valves back to their seats.
Application:
These rods link the cam to the valves. These are very costly so please call for good used ones.
