Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These cables set the rear brakes.
These cables set the rear brakes. When installing the new cables use white grease on them. Make sure you have adjusted your rear shoes before tightening the cables.
No customer reviews for the moment.
Part #: N102425
This is a list of the most common bolts used on a car..
Application:Part #: W7CC
When replacing these use anti-seize on the threads.
Application:Part #: 211141031L
This disc transfers the power from the motor to the transmission.
Application:Part #: 211703120AX
This is where you would put in the stock jack to jack up the bus.
Application:Part #: 111941191
This seal goes in the headlight buckets.
Application:Part #: T1905200
This puller removes the distributor drive shaft.
Application:Part #: 1101130
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1119031BHD
Motors with high horsepower and motors that rev fast run the risk of exploding a stock fan.
Application:Part #: 151863376
These rear kick panels go between the rear seat frame and floor.
Application:Part #: 113255359
The heater hose goes from the fan shroud to the heater boxes.
Application:Part #: 111119270B
This is a hub that is keyed onto the generator or alternator to mount the fan.
Application:Part #: N130101WG
Pan Head Screw for Bus 3 Gauge Pod
Application:Part #: 113823531G
This the cable you pull to release the front hood.
Application:Part #: 311301343
Sleeve
Application:
These cables set the rear brakes.