Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:Heater Box T2 Right Non-CA
Heater Box T2 Right Non-CA
Bus (Type 2): 1978-79
No customer reviews for the moment.
Part #: 111837507
This is the mechanism that makes the window go up and down.
Application:Part #: 151871357A
These are the rear quarter wedges for your convertible..
Application:Part #: 211703475G
This support goes inbetween the main frames of your Bus.
Application:Part #: 113798073B
This is what gets smashed up first in an accident.
Application:Part #: 311927147B
Neutral safety switch
Application:Part #: 111837476A
The front door window rolls up and down between these two rubber seals.
Application:Part #: 211847439A
This seal is for factory safaris only.
Application:Part #: 211953142T
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 251837211
This seal goes between the handle and the body.
Application:Part #: 211827401
Engine Deck Lid Prop Spring
Application:Part #: 1711149B
Stock Shifter Assembly, Straight with 12mm Thread + Knob
Application:Part #: N113401
Dimmer Switch Screws, Mounts dimmer switch to vehicle, Pair
Application:Part #: 6201550B
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 111837235GY
This plastic "donut" goes under the window crank or door handle to prevent the door panel from getting ripped.
Application: