Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two rods go from the steering box on a Bug, to the spindles, making the car turn.
These two rods go from the steering box on a Bug, to the spindles, making the car turn. To inspect the rods, have a friend turn the steering wheel back and forth a little while you place your hand on the top of one of the tie rod ends. The tires have to be on the ground or ramps. You can not do this test with the wheels hanging free. If you can feel the end jump up and down before it pushes or pulls, it's bad. On some tie rods it's possible to change just the ends. On other tie rods, the ends are swedged on and the whole tie rod will need to be replaced. Usually you replace just the end unless the rod is bent or has the swedged ends.
No customer reviews for the moment.
Part #: 111405691B
This is the cap that goes on the outside of the drum; covering up your bearing.
Application:Part #: 151701061B
Floor Plate, Left, Convertible only
Application:Part #: 113129710D
Dual Port Manifold End Casting - Right
Application:Part #: 111998162
The wiper arms are connected to these shafts.
Application:Part #: 651300418
Suspension Limit Straps 18", Pair
Application:Part #: 211707362B
This pan goes between the rear bumper and the body on the corners of your bus..
Application:Part #: 1707135ACH
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 111837581J
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
Application:Part #: 151857502B
These mirrors mount on the doors or door hinges so you can see what's behind you.
Application:Part #: 6721550A
HD Throttle Cable 16'
Application:Part #: 2251006CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 2101303
Whether your motor lives or not can depend upon this little shim.
Application:Part #: VCP25
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 113415801
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: 113129191G
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1601099
These are studs and nuts for different types of wheels.
Application:
These two rods go from the steering box on a Bug, to the spindles, making the car turn.