Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is the pin and the spring needed on the accelerator pedal.
This is the pin and the spring needed on the accelerator pedal. It is a good idea to buy this kit if you are replacing the accelerator pedal.
Bug (Type 1): 67-79
Type 3: 66-74
Ghia: 66-74
Thing: 73-74
Race/Off-Road: 66-79
No customer reviews for the moment.
Part #: 1615109SWG
This kit allows you to run disc brakes in the rear.
Application:Part #: 113867500
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 151863014
These are the interior panels.
Application:Part #: 343853343
Seal between Roof and Molding
Application:Part #: 311953153
Front Turn Indicator Seals, Set of 2
Application:Part #: JC44490
Jaycee Billet IDA Stacks, Polished, Each
Application:Part #: 211201255
This collar goes around the gas tank neck on buses 1955-1967.
Application:Part #: 1198088A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N185101
These fittings fit on the front end so you can pump grease in the front suspension..
Application:Part #: N177191
These are some of the fuses and bulbs that you might need.
Application:Part #: 1301048
These straps are a good idea if you have a car with a big engine. We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 6401023
These clamps are made to go around your front axle beam and are used when building rail cars or stiffening up the front head of a baja Bug..
Application:Part #: 021903655B
Boot for Alternator Cooling
Application:Part #: 113609237A
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 211615108CO
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 111105223
This brass gear goes on the crank to turn the distributor drive shaft.
Application: