Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the seals that go around the push rod tubes. On all Bugs and Buses up to 1971 the heads have to come off to replace the seals and we highly recommend you replace the tubes at this time as well. If you don't they will usually leak even though you have new seals. On buses 1972 on, the seals can be replaced by pulling the rockers off and the wire clip that holds the tubes in place. Use a pair of pliers to wiggle the tubes out. Wipe some white grease on the new seals and install.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 111957397
This holds the dash lights into the speedo head.
Application:Part #: 151837633A
Vent Wind Upper Pivot Screw, Convertible
Application:Part #: 213707155A
Front Bumper Guard
Application:Part #: 6.2010711E+018
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 151871357A
These are the rear quarter wedges for your convertible..
Application:Part #: 6801111
These tabs are used for mounting just about anything to tubing..
Application:Part #: 115875335B
Sunroof Front Mechanism Inner Sliding Blocks (Pair)
Application:Part #: 1501623
Aluminum Wheel Spacer, Double Drilled 4x130 & 5x130; 1/2" Thick
Application:Part #: 113885553
These are the stops that the back of the rear seat rests on.
Application:Part #: 1412032B
This is the only correct way to lower the front end of a Super Beetle.
Application:Part #: 6857646
Billet Foot Pegs, 1/2" X 20 Threads, Pair
Application:Part #: 211863160
These are the interior panels.
Application:Part #: 211405645D
These bearings go in the drum or rotor hub to allow them to spin.
Application:Part #: 112920234
34mm Main Venturi for 40/44 HPMX (EMPI), 44 IDF (WEBER)
Application:Part #: 111498001
Front axle lock plate kit
Application:Part #: 1251211B
Brass Exhaust Nuts 8mm-1.25 thread, 11mm Head (100 per kit)
Application:
