Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This nut came on all dual relief cases.
This nut came on all dual relief cases. This is because with a doghouse cooler it is near impossible to get a nut off or on once the engine is in. If you're putting a dual relief case on a transmission that took a single relief case, make sure you grind off the locking boss for the bolt on the clutch arm side before you put the motor in. Be careful not to crack the case when installing. Rig up a pipe that has a notch to match the notch on the flywheel side of the case. Draw the nut into the case with a bolt.
Bug (Type 1): 71-79
Bus (Type 2): 71
Type 3: 71-74
Ghia: 71-74
Thing: 73-74
Race/Off-Road: 71-
No customer reviews for the moment.
Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1101211
This chrome stand dresses up your engine.
Application:Part #: N104701
These are the bolts that hold the engine in.
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: 040101149
Oil pick up Pipe
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:
This nut came on all dual relief cases.
