Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is the front brake rotor that the pads ride against on the disc brake front ends.
This is the front brake rotor that the pads ride against on the disc brake front ends. Note: When tightening the bearing nut, snug it down against the bearing thrust washer. Now line up the handle of your wrench with one of the lug bolts and back the nut off so the handle of the wrench lines up with the next bolt (a fifth of a turn). Those useing four lug rotors back off just before the next lug bolt. This will prevent bearings from heating up and wearing out.
Bus (Type 2): 71-72
No customer reviews for the moment.
Part #: 211615108
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 211615107
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 311941177H
This chrome metal ring goes around the headlight.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 1251199
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 211251053C
This is the exhaust silencer.
Application:Part #: 211698002A
This kit has all the springs, for drum brakes.
Application:Part #: 111809085CB
Fastening Panel, Rear Fender
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 151847346B
These scrapers found on convertibles are for the rear quarter windows.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 113857117B
This plastic ring goes around the dash for the glove box.
Application:Part #: 113857551ABK
These are the visors you pull down to keep the sun out of your eyes.
Application:Part #: 1831051
These trim covers are for the interior of your car where your feet are likely to hit.
Application:Part #: 1129505007
These are some of the most common jets used.
Application:Part #: 111801042CX
Inner Rocker Panel Right side repair panel
Application:Part #: 1105255BK
This is a very nice pulley; the numbers are etched in and do not wear off.
Application:Part #: 131601155
Beauty rings fit under the hubcap to improve the look of your stock rim.
Application: