Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the seals that go around the push rod tubes.
These are the seals that go around the push rod tubes. On all Bugs and Buses up to 1971 the heads have to come off to replace the seals and we highly recommend you replace the tubes at this time as well. If you don't they will usually leak even though you have new seals. On buses 1972 on, the seals can be replaced by pulling the rockers off and the wire clip that holds the tubes in place. Use a pair of pliers to wiggle the tubes out. Wipe some white grease on the new seals and install.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 211801351A
Cargo Floor Cross Member, 1 per bus
Application:Part #: N141251
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 71028
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 111598051A
The rear axle seal kit comes with the necessary replacement gaskets, o-rings, washer and seal for the bearing cap.
Application:Part #: 113611701D
This flex hose goes from the metal brake line to the front wheel cylinder.
Application:Part #: 144883405
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 211301297
Front Transmission Mount
Application:Part #: 113853535B
This is the chrome trim that went on the front and sides of the Bug to dress it up.
Application:Part #: 1805057
This tray mounts behind the rear seat.
Application:Part #: 113953161BCL
Clear Turn Signal Lens, Left
Application:Part #: 021101481
This gasket goes between the valve cover and the head.
Application:Part #: 113412329B
SB Strut Upper Mount w/ Bearing
Application:Part #: 6513002
Coil Over Shocks for Link Pin Front, All Rears, All Chrome, Pair
Application:Part #: 1805050
This bamboo tray fits under the dashboard of a T1 sedan, providing a handy shelf to keep all of your "stuff" within easy reach.
Application:Part #: T1105245
If you're going to be putting more than one engine together, we highly recommend getting this seal installer.
Application:
These are the seals that go around the push rod tubes.
