Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the seals that go around the push rod tubes.
These are the seals that go around the push rod tubes. On all Bugs and Buses up to 1971 the heads have to come off to replace the seals and we highly recommend you replace the tubes at this time as well. If you don't they will usually leak even though you have new seals. On buses 1972 on, the seals can be replaced by pulling the rockers off and the wire clip that holds the tubes in place. Use a pair of pliers to wiggle the tubes out. Wipe some white grease on the new seals and install.
Vanagon: 83-91 (Outer)
No customer reviews for the moment.
Part #: 211798002A
Bumper Bolt Kit
Application:Part #: 2898061
Aluminum Side Steps
Application:Part #: 1251262
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 62010718000000
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 113115181A
This is the plate on the bottom of the motor.
Application:Part #: 191611349A
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 111953161AM
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 311511245
This rubber "donut" goes around the spring plate, allowing it to move up and down.
Application:Part #: 211809101B
This is what everyone cut out in the 60's.
Application:Part #: 211801404DJ
This is a section of ther rear cargo floor.
Application:Part #: 1711142BR
These knobs are made to fit all stock shifters and come with the shift pattern.
Application:Part #: 151701061M
Floor Plate, Left, Convertible only
Application:Part #: 113857553
Mount Rod for Right Visor
Application:Part #: N203011
Washer Hose, Black Rubber, Per Foot
Application:Part #: 221847081D
These are the latches that hold the popout frame out.
Application:Part #: 113611055
This hydraulic slave cylinder is found in the front brake backing plate.
Application:
These are the seals that go around the push rod tubes.