Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bus (Type 2): 1.9, 2.1
No customer reviews for the moment.
Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 021109641B
Valve Spring Retainer
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:Part #: 1101386
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1109602
Valve seats are used in the big valve heads.
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 2101309
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111198157A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:
