Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The hood catch is what the pin of the hood latch goes into.
The hood catch is what the pin of the hood latch goes into. Adjusting the hood catch will try your patience. After you bolt it in, tie a wire around the catch lever and leave it hanging out the front. Now slide the cable into the barrel lock. With your finger, pull the lever over until it is half way through the hole or until it starts to kick back the other way. Tighten the barrel lock on the cable at this point. Now close the hood slowly making sure the pin on the hood is going to hit the center of the hole in the catch. If not, don't close the hood. Readjust the catch or the latch until it does, then push the hood close and it should latch. If you are having to slam the hood, you're out of adjustment somewhere. If you can hear the hood catch, try and pull the release and see if it opens. If it does, open it and remove your temporary wire. If it doesn't, try pulling on the temporary wire to release it. If that doesn't work, then you have to cut the handle off to get the hood open. Remember to take your time.
Bug (Type 1): 68-77
No customer reviews for the moment.
Part #: 1070274LK
This rack fits on the roof of your bug and clamps down in the rain gutter.
Application:Part #: 111801172C
The heater channel carries heat form the heater boxes to the front of the car.
Application:Part #: 261881370
This is the padding that sits on top of the springs of the seat.
Application:Part #: 151701061B
Floor Plate, Left, Convertible only
Application:Part #: 213707356A
Rear Bumper Overrider, Right
Application:Part #: 111881251B
This knob goes on the handle that moves the bottom of the seat forwards and backwards.
Application:Part #: 1601102C
Lug nuts for a wheel that takes a ball or acorn style seat.
Application:Part #: 211609439D
Rear Backing Plate Left
Application:Bus (Type 2); 68-70
Part #: N185163
Screws-- 4mmx10mm Counter sink
Application:Part #: 211829221B
Bus Rear Hatch Striker Plate, Single Cab Side Compartment Striker
Application:Part #: 111198569A
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 6707302KT
These bumpers are made for Baja Bugs.
Application:Part #: 1837225
These window cranks and door handles are a nice way to give the interior of your car a sporty look.
Application:Part #: 211809505B
The lower part of the dog leg.
Application:Part #: 6801227
Billet Shaped Bracket, 1 3/4", 3/8-16 Threads
Application:
The hood catch is what the pin of the hood latch goes into.